+ Reply to Thread
Results 1 to 5 of 5
  1. #1
    Join Date
    Feb 2008

    Default Kitchen Island legs

    How do we secure the island legs to the wood floor? I thought I saw how it was done in an issue of TOH mag. but can't locate the article. Thanks

  2. #2
    Join Date
    Aug 2008
    San Diego, CA

    Default Re: Kitchen Island legs

    If you haven't installed the legs yet, you can cut a "foot" and screw it to the bottom of the leg. Of course you would cut the leg shorter by the thickness of the foot. Once you have the foot on the bottom it should stick out beyond the face of the leg and you can nail or screw it to the floor. The foot could be dressed up with a router to have a moulded edge or chamfered edge to make it look like it belongs there.

    If you have the leg already in place and can't screw the foot onto the bottom of the leg, you could always cut the leg in place, the thickness of the foot and then slip it under the leg. Once in place, you could toe nail it onto the leg and then anchor the foot to the floor.

    Hope this helps.

    Good Luck.

  3. #3
    Join Date
    Nov 2007
    Sand Springs, OK

    Default Re: Kitchen Island legs

    How about gluing it to the floor.

    I think it would be better to just let the legs float on the floor to allow for expansion and contraction of all the wood involved.
    Debby in Oklahoma

  4. #4
    Join Date
    May 2008
    Pacific Northwet

    Default Re: Kitchen Island legs


    1. You could drill a hole in the floor, one in the leg, and glue a dowel pin in place; then it would be completely hidden.

    2. Use a dowel screw instead of a dowel pin. This will require installing the legs first, then attaching the rest of the island to the legs. It should be stronger than a dowel pin, as it's steel instead of wood.

    3. You could run a hanger bolt into the floor, drill a hole into the end of the leg to accept it; drill a hole in the side of the leg to accept a threaded insert and put a set screw in the threaded insert tightened up against the hanger bolt. Cover the set screw/insert with a wooden plug or button.

    Hanger bolts & dowel screws:

    Threaded inserts:

    Dowel pins, plugs, buttons:
    The "Senior Member" designation under my name doesn't mean I know a lot, it just means I talk a lot.I've been a DIYer since I was 12 (thanks, Dad!). I have read several books on various home improvement topics. I do not have any current code books I can refer to. I was an apprentice plumber for two years.

  5. #5
    Join Date
    Jan 2008

    Default Re: Kitchen Island legs

    You can pretty much use any technique that would work in a similar situation and materials (floor surface, subfloor type counter support type, wall/cabinet structure) as you would use to install a newel post for a stairway banister in a similar configuration (free standing or from a wall). You need security and stability in your installation to resist tear out and support the loads.

    Hope that helps.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts