+ Reply to Thread
Results 1 to 4 of 4

Thread: Hide Wood Grain

  1. #1
    Join Date
    Mar 2010
    Posts
    4

    Question Hide Wood Grain

    I am going to be painting oak kitchen cabinets white and would like to hide the wood grain for the finished product. Anyone got any ideas on how to do this? I am going to be using a HPLV Spray gun when I do paint them

  2. #2
    Join Date
    Jan 2010
    Location
    Northern Virginia
    Posts
    975

    Default Re: Hide Wood Grain

    Remove not the ancient landmark, which your fathers have set.

  3. #3
    Join Date
    Jun 2007
    Location
    Fayette County, Ohio
    Posts
    5,560

    Default Re: Hide Wood Grain

    Use a grain filler. On oak I would recommend an oil based filler because it is less likely to raise the grain. Sand and apply finish.
    Jack
    Be sure you live your life, because you are a long time dead.-Scottish Proverb

  4. #4
    Join Date
    Aug 2007
    Location
    Portland, Oregon, formerly of Chicago
    Posts
    1,587

    Default Re: Hide Wood Grain

    Grain fillers, as JLMCDANIEL recommends, are intended for filling grain prior to staining. I believe you are talking about existing varnished cabinets?

    I am not familar with the product suggested by Sombreuil. At $110for 2.5 liters (less than 3 quarts), I hope it would be good! It appears to be a very high solids, high build oil based enamel undercoater. It has a very long dry time.

    In the past, I have used oil based enamel undercoater to mask undesired grain and texture. Enamel undercoater is designed to build up the surface and then be sanded smooth. I have used it to mask oak graining. I also used it for masking "ropey", brush marked past paint jobs.

    You apparently have HVLP equipment. I would consider spraying the doors in a horizontal position, so as to allow maximum build without risking running or sagging. Unfortunately, this neccessitates spraying on two separate days, or at least, several hours apart. I would thin the primer sparingly. Mild splatter will be eliminated during a thorough hand sanding.

    In the worse case scenario, a second coat of undercoater might be neccessary to obtain the desired build( this is also suggested with the brushing putty named in the above post).

    The standard preparation applies - clean well and give a scuff sanding before undercoating.

    I am partial to spraying an oil finish coat, however, oil paints do tend to yellow with age. Acrylics do not yellow, but fail to get hard, retaining a gummy, sticky feeling, especially in humid weather.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •