+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    Join Date
    Feb 2010

    Default Door Casing too wide

    I want to install 1x4 molding with a back band on my interior windows and doors. The issue is that the profile will be too wide for some doors (near corners etc.). How should this be handled for those instances use a smaller molding (1x3) with back band or eliminate the back band and cut 1x to width?

  2. #2
    Join Date
    Jan 2010
    Northern Virginia

    Default Re: Door Casing too wide

    I have seen it done two ways. Separate backband left off entirely on short side, or cut down narrower, but crowding it over is mostly not done. (It's OK if the movement is slight, like 1/4" or less) If it were a solid molding, casing and backband molded in one, carving down the edge would be the only way.
    But anyway; mock it up, take a look at it for yourself, and go with what you like.
    Remove not the ancient landmark, which your fathers have set.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts