+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    Join Date
    Aug 2008
    Posts
    1

    Default Stained Glass Panel Installation

    This is probably not your normal question for this doors and windows section but I though that someone may have some insight for me.

    We have a stained glass panel, approximately 49 inches long and 7.5 inches tall which is to be installed into a transom vinyl window. The catch is not to drill any holes in the vinyl window.

    I'm looking for any ideas.

    Thanks in advance

    Bruce Patterson
    Richmond, VA

  2. #2
    Join Date
    Aug 2008
    Location
    San Diego, CA
    Posts
    367

    Default Re: Stained Glass Panel Installation

    Glue it to the existing window, using a tube of silicon caulk.

    If you EVER want to take the stained glass off the window, use the caulking VERY sparingly (ie. don't run a bead of it all the way around the window) or you'll take the stained glass out of the window in very small pieces. (voice of experience speaking)

    Just put a little gob of the caulk at each corner. I mean very little. About the size of a pencil in diameter. It has incredible holding power. Use some masking tape to hold the stained glass in place for 12-24 hours. Then take off the tape. You're done.

    Good Luck.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •