+ Reply to Thread
Results 1 to 4 of 4
  1. #1
    Join Date
    Aug 2008
    Posts
    1

    Default Crown Molding On Plaster Walls

    What is the best way to install crown molding on plaster walls?

  2. #2
    Join Date
    May 2008
    Posts
    0

    Default Re: Crown Molding On Plaster Walls

    use multiple layers. use a ledger made of 1" stock (X 6" or larger) depending on crown size. when secured to wall it will feather out the irregularities over length and the valleys can be caulked. you should also use a backer cut to the pitch of the crown which provides for top and bottom nailing.

    mike

  3. #3
    Join Date
    Jun 2007
    Location
    Fayette County, Ohio
    Posts
    5,621

    Default Re: Crown Molding On Plaster Walls

    First find and mark the stud location, then cut a 1x as shown below that fits in the opening behind the crown. Nail the 1X into the studs then install the crown nailing it to the 1X.
    Jack
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	untitled.JPG 
Views:	82 
Size:	2.4 KB 
ID:	1490  
    Be sure you live your life, because you are a long time dead.-Scottish Proverb

  4. #4
    Join Date
    Aug 2008
    Location
    San Diego, CA
    Posts
    367

    Default Re: Crown Molding On Plaster Walls

    I agree with Jack's suggestion to use the 1x2 and cut 45degree angles on each end.

    Assuming your ceiling is relatively uniform, you might want also to snap a chalk line on the wall to get the bottom end of the 1x2's in a straight line. It makes the back of the crown mold fit flat against the backers. I've used this method and it worked very well for me. I screwed the backers to the studs with long drywall screws.

    Good Luck,

    Mike

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •