Re: Bathroom leak with drain pipe
Patty it's hard to tell for sure from the picture but it looks like you have the P trap shoved to far into the wall and it is putting side pressure on the PVC pipe. It looks like the PVC is at an angle as it enters the metal trap that''s why there is a gap. Loosen the compression fitting at the wall so you can slide it out until it lines up with the PVC. Loosen the nut at the PVC also so the gasket can seat properly with the straight connection then tighten the compression nuts.
Last edited by JLMCDANIEL; 06-26-2008 at 10:18 PM.
Be sure you live your life, because you are a long time dead.-Scottish Proverb