Results 1 to 2 of 2
  1. #1
    Join Date
    Sep 2009

    Default Add new work to old metal box

    My condo was built in 1968. The wiring was installed using metal conduit, metal workboxes. Since 1968, there has been a major remodel (1982), where nothing appears to have been changed. Subsequent occupants have brought the addition of a few switches, outlets, utilizing remodel boxes and a hot feed from the adjacent (old) box. We are about to undergo a minor, owner (me) driven kitchen remodel, and I want to streamline the work that has been done. Generally, this would mean removing the new remodel box and ganging switches or outlets in the original location (not the box, since there wouldn't be enough room).

    How do I remove the original metal box? I have the basics down for getting off the wood stud, but the box is fastened to the metal conduit with an EMT connector. Since there is no ground in these boxes, I also assume (ass-u-me) that the conduit is my ground (it appears that way at the panel, too) and I would have to replace the original metal workbox with a new metal remodel box.

    Of course, I am looking to do this with minimal wall damage - which is why the question here.

  2. #2
    Join Date
    Mar 2009

    Default Re: Add new work to old metal box

    you would assume correct that it is your ground. taken into account its done properly. im not entirely sure your question, if your asking how to get the pipe off the box in an existing wall with out damagain the wall?? then i would take the lock nut off the connector and try and pry up the pipe as much as possible. i dont know if ya can get i there with a wonderbar, hammer, screw driver? good luck

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts