I'm totally lost.....We tore down an old shed that had 14.2 wire ran to it. There was a washer, dryer, an old chest type freezer, and a light. So now we have removed the old shed and had a new one built. We have 14.2 wire ran to this shed with 4 recepticals and a light on this wire. We use a voltage detector and we have voltage but as soon as we plug in a lets say a surge protector we have no voltage in the surge protector. It will not power up a fan a light or nothing. This wire is hooked to a 30 amp cutler hammer breaker. ANY SUGGESTIONS?????