# Thread: Load Bearing header

1. Junior Member
Join Date
Mar 2008
Posts
2

## Load Bearing header

How do I calculate how large of a header to have for a load bearing wall with an opening of 7 feet. I have the space to double up or even tripple up beams to add strength. Currently there are two 2x10s with 2 2x4 (laying on side) on top. I need more floor to bottom of header space and this 14 inch header seem like over kill for a 7 foot span.

thanks

2. Senior Member Rank 2
Join Date
Nov 2007
Location
Sand Springs, OK
Posts
467

## Re: Load Bearing header

2 inches for every foot of length sounds good to me but I looked up a sight that says:

Calculating header size is complicated. You have to take into account: (1) the length of the window or door opening; (2) the combined weight of the floors, walls and roofs above; (3) the building width; (4) the snow load in the area; (5) whether it’s a bearing wall (where joists, trusses and rafters rest) or a non-bearing wall (to which joists, trusses and rafters run parallel); (6) whether it’s an exterior or interior bearing wall; and (7) what species of wood you’re working with.

The 2000 International Building Code book contains two full pages of mind-numbing charts for calculating proper header sizes in different situations. Fig. B shows the maximum allowable spans for different size headers in just one situation. As you’d expect, the deeper the header, the longer the distance it can span. But trust me, you don’t want to wade into all the technicalities. There’s no simple formula. My advice is this:

Have an engineer or architect calculate the required header size for your window and door openings.

Ask your local building code official to help you calculate header size. It’s usually not in their job description, but the nice ones will help you out.

When in doubt, build a double 2x12 header sandwich like we explain next. In all but the most bizarre situations, they’ll easily carry the weight for 4-ft. wide window and door openings and, in most situations, be code compliant for openings up to 6 ft. wide—a common patio door width.

FIG. B
HEADER SIZE MAXIMUM SPAN NUMBER OF TRIMMERS

Double 2x6 4 ft., 0 in. One

Double 2x8 5 ft., 0 in. Two

Double 2x10 6 ft., 2 in. Two

Double 2x12 7 ft., 1 in. Two
From The Family Handyman by Reader's Digesthttp://www.rd.com/familyhandyman/content/18202/

But you need to go with what your local code demands as well so pay an expert to calculate it for you not a housewife with computer access in Oklahoma
Last edited by debbysewn; 03-08-2008 at 04:15 PM. Reason: errors

3. ## Re: Load Bearing header

debby nailed it (pun ) ... nobody from here can tell what loads are there.

To say the existing header is overkill .... maybe .... chances are it's that size for a reason. There could be a second storey and the header is under a bathroom for all we know from here ... good advice given is to consult with an engineer.

You might be able to use an LVL or similar engineered beam ... but that would have to be determined by a professional.

Just my 2 cents.

4. Junior Member
Join Date
Mar 2008
Posts
2

## Re: Load Bearing header

Thax for the input. Looks like what is there is correct and I need to work around it.

#### Posting Permissions

• You may not post new threads
• You may not post replies
• You may not post attachments
• You may not edit your posts
•