+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    Join Date
    Jan 2008

    Default Baseboard Heat Noise

    When my baseboard heating unit turns on, in some rooms, it sounds like someone is taking a hammer to the pipes. What is the cause and how can I fix it?


  2. #2
    Join Date
    Feb 2008

    Default Re: Baseboard Heat Noise

    I've had the same problem and here's what I've read... Good luck!

    Baseboard heat noise solutions:

    • Plastic gliders (not metal)
    • Expansion compensators on long runs
    • Outdoor-air reset control (water cycles continuously, varies boiler temp)

    Banging (water boiling – check temp, should be less than 210 at all times – have read less than 220.)
    • TURN BOILER TEMP DOWN! this is dangerous.

    Banging (pipe expanding against too-small hole in floor or wall)
    • Bleed system
    • Bigger hole
    • “high heat caulking compound” applied to hole
    • Outdoor-air reset control mitigate but not solve

    Banging (fast-closing zone valve – before circulator stops)
    • Bleed system
    • Check expansion tank
    • fast-closing cause this: Honeywell, Erie, small White Rogers
    • slow-closing solve: Taco, large White Rogers

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts