Last edited by asc2078; 08-18-2008 at 04:58 PM.
Nope.I'd rather plaster it NO DUST although this trade is what I do.
Haven't tried it, but......
As stated earlier, there doesn't need to be much dust when using joint compound. Don't apply it too thick, knock off the nubs with the knife before putting in the next coat and feather it out. Minor sanding is all that is needed after the final coat. Some even successfully "sand" with a wet sponge to limit dust.
Practicing in a closet, furnace room or laundry room is helpful until you have your technique developed!!
Last edited by bp21901; 12-12-2007 at 01:43 PM. Reason: speling eror
Yes I am using it mow and it works real good. You have to thin it just a bit or its hard to spread. Sand it with a wet dry sanding sponge and you get no dust at all. If you use regular sandpaper you do get dust but it sort of fall straight to the fl
oor. The wet sponge sanding is a lot eaasier and quicker
Good luck finding it I had to order it out of Dallas and freight is high on that stuff. oneputt
In additional to wet sanding. They also have dustless sanders that hook to your shop vac.
I just finished a job in my dining room. No dust problem. Just sucks it right off as you sand it off. I modified mine for a residential vac. Worked perfect. I even did the ceiling w/ a pole sander version. No issues.
This stuff is great, sands very easily and the dust particals are not as fine as with typical mud, everything falls straight down, does'nt float in the air. Much better for clean-up and definately better on the lungs.
I used the dustless mud, and IMO it is only suitable for high work, as it is way too soft to stand up to ordinary handling. It is very subject to dents dings and sc****s.
With the softness and dust-reduced characteristics, it's good for ceilings. But that's the only place I'd recommend it.
Remove not the ancient landmark, which your fathers have set.
works well and with my porter cable sander and vac they work great, when you are needing to be in a dustless environment.