+ Reply to Thread
Results 1 to 5 of 5
  1. #1
    Join Date
    Sep 2009
    Posts
    9

    Default Wiring around a corner

    I am remodeling my master bedroom right now and currently I am down to studs. I started wiring today and ran into a problem. I have to turn a couple of corners on two seperate runs. How do I turn the corners? I cannot figure it out...

  2. #2
    Join Date
    Mar 2009
    Location
    OKC
    Posts
    247

    Default Re: Wiring around a corner

    have you tried drilling from both directions?
    HOPE THIS IS HELPFUL!

    Oklahoma City, OK

  3. #3
    Join Date
    Sep 2009
    Posts
    9

    Default Re: Wiring around a corner

    I have from one side but cannot fit my drill in from the other.

  4. #4
    Join Date
    Mar 2009
    Location
    OKC
    Posts
    247

    Default Re: Wiring around a corner

    you might have to buy a flexible drill bit, they are a couple of feet long and the shaft is flexible so you can get it in tight spots.
    HOPE THIS IS HELPFUL!

    Oklahoma City, OK

  5. #5
    Join Date
    Sep 2009
    Posts
    9

    Default Re: Wiring around a corner

    I just got it. I forgot about using my impact drill. Used that as it was shorter than my regular drill. Thanks for the help.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •