+ Reply to Thread
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. #11
    Join Date
    May 2009
    Location
    Elyria, Oh.
    Posts
    245

    Default Re: Water Heater Installation Cost

    The ground wire between the hot and cold water pipes is called bonding. The NEC 250.104 requires that metal water piping systems "shall be bonded as required..." The same principle applies at your water meter as there is a jumper around the meter in case the meter is removed to insure that the electrical system stays grounded. In this case when the hot water heater was removed the hot water piping system would be temporarily ungrounded if there was no bonding wire between the cold and hot water piping systems. Sometimes hot water heaters used dielectric unions because of dissimilar metals so you cannot assume that the hot water piping system is grounded through the hot water heater itself.

  2. #12
    Join Date
    Dec 2008
    Location
    Midwest
    Posts
    173

    Default Re: Water Heater Installation Cost

    they should have put in an expansion tank. most cities it is code now.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •