+ Reply to Thread
Results 1 to 3 of 3
  1. #1
    Join Date
    Jun 2012
    Location
    West Michigan
    Posts
    33

    Default new moen sink cartridge sticking - help

    I replaced the cartridge in a Moen sink faucet a few months back. The setscrew came loose on the handle and it seemed like it was taking more effort to turn side to side, so with the help of my 3 y/o I pulled the whole thing apart today. After putting plumbers grease on the outside of the cartridge and putting everything back together, the handle turns side to side well, but it takes significantly more effort to raise the handle to turn the water on and off.

    What did I do wrong?

  2. #2
    Join Date
    Feb 2010
    Location
    South*East
    Posts
    1,168

    Default Re: new moen sink cartridge sticking - help

    Your putting the handle on wrong. There is a round loop on the handle that must fit on the groove in the nut that holds the spout and cartridge in place. When putting the handle on tilt the handle towards the back of the faucet so the loop fits into the groove. then tilt it forward into place.
    John

  3. #3
    Join Date
    Feb 2012
    Posts
    92

    Default Re: new moen sink cartridge sticking - help

    Sounds like john's correct it fits on kind of like a baseball cap.
    Ben Franklin Plumbing
    372 D St
    Salt Lake City, UT 84104
    (801) 416-3522
    http://www.benfranklinplumbingut.com/salt-lake-city-ut/

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •