+ Reply to Thread
Results 1 to 8 of 8

Threaded View

  1. #1

    Default hot water loop #2

    [This is a picture of the 2 lines that I disconnected when I went from 2 sinks to 1. I did not attach either one when I hooked up the new lines for the 1 sink . I do not have any fixtures attached to any lines, ( shower, toilet and new sink ). I was just doing leak test before putting up walls . When I turn on the water to the new lines ,I lose hot water to whole house . Nothing crossed , and water does come out, but not hot water. Do I need to hook up one of the disconnected lines to new hot water line.? I thought they were hammer resisters.
    Last edited by captainmuscle11; 01-29-2013 at 03:26 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •