Replacing Triple Switch Single Gang
I have been slowly replacing switches in an old colonial. This section of the house was built (addition) right after WW2. The outlets are two prong (another matter altogether) and the wiring is cloth wrapped.
I've been replacing and keeping the existing wiring configurations, however I popped out the switch and see quite a mess. The replacement three switch I purchased doesn't have enough screws to attach the incoming wires.
Since the picture size limits on here are kinda ridiculous, I've linked to pictures I took of the existing switch as is. I can also upload pictures of the new switch if that will help.
- Pic 1: http://www.carringtonfisk.com/wp-con...0/DSC08527.jpg
- Pic 2: http://www.carringtonfisk.com/wp-con...0/DSC08526.jpg
I'm hoping for some insight as I've only just recently graduated from NOOB status.