+ Reply to Thread
Results 1 to 4 of 4
  1. #1
    Join Date
    Feb 2009
    Posts
    2

    Default New cartridge/o ring...still leaky!

    I have replaced the cartridge (which included the o rings for my kitchen faucet...this brings the dripping to a halt but when I begin to put it back together and twist the screw that goes into the new cartridge, the leak starts again. I am at a loss!! What am I missing??

  2. #2
    Join Date
    Jun 2007
    Location
    Fayette County, Ohio
    Posts
    5,836

    Default Re: New cartridge/o ring...still leaky!

    Remove the cartridge and look down in the bottom of the faucet well. You should see a rubber washer in the hole where the water comes up, pull that out along with it's spring. It will be a small spring and a small rubber washer sort of shaped like a cup. Replace those two items. Thats what usually cause a faucet to drip, the "o" ring would cause water to seep out around the handle. At least that is the way our Delta works. It's item #19 in this drawing


    Jack
    Be sure you live your life, because you are a long time dead.-Scottish Proverb

  3. #3
    Join Date
    Feb 2009
    Posts
    2

    Default Re: New cartridge/o ring...still leaky!

    I looked, but don't have one of those! I have a single "lever" kitchen sink faucet too...it's by Moen. I don't know if that matters??

  4. #4
    Join Date
    Jun 2007
    Location
    Fayette County, Ohio
    Posts
    5,836

    Default Re: New cartridge/o ring...still leaky!

    Go here http://www.moen.com/buymoen/buyparts/index.cfm and find your faucet, check to make sure you have the right cartridge. If you have to wrong one or a generic cartridge, the stem may be short and when you tighten down the screw it is pulling up the cartridge. You can also print out and assemble diagram. You may need to replace pivot retainer or handle adapter kit depending on model.
    Jack
    Last edited by JLMCDANIEL; 02-12-2009 at 11:30 PM.
    Be sure you live your life, because you are a long time dead.-Scottish Proverb

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •