Search:

Type: Posts; User: rephil34

Search: Search took 0.08 seconds.

  1. Replies
    2
    Views
    365

    new water heater

    I recently installed a new walk in shower, with 3 body sprays and a 10" rain shower. All this will use 10 gpm. I am trying to find out, what will be the best way to replace my 40 gal gas water...
  2. Replies
    5
    Views
    375

    inconsistant mixing valve

    I have a Symmons safetymix mixing valve. when we turn on the shower, the water stays hot for a minute or so, then goes cold and we have to readjust the temp again, then it will stay hot. it has...
  3. Thread: heat zones

    by rephil34
    Replies
    4
    Views
    339

    Re: heat zones

    yes, it is heating when not calling for heat. but it doesn't go all the way through the loop. the beginning of the loop will be about 120 deg and the end of the loop will be about 65 deg.
  4. Thread: heat zones

    by rephil34
    Replies
    4
    Views
    339

    heat zones

    I have a 3 zone FHW system with 3 separate circulators. when circulator 1 or 2 come on, :cool:heat goes to the first baseboard in the 3rd zone, but does not go all the way through the 3rd zone. the...
  5. Replies
    3
    Views
    389

    new water heater

    I just built a custom shower with 3 body sprays, a rain shower head and a hand held sprayer. I figure i need about 10gpm min..I currently have a 40gal. heater and a 3/4" dedicated line to the shower....
  6. Replies
    6
    Views
    1,559

    running new drain

    what is the proper way to run a 2" drain perpendicular to floor joists?
    can i laminate 3/4" plywood to joists then drill 2 1/2" holes in joists?
  7. Replies
    1
    Views
    286

    new bath drain

    is there a proper way to run a 2" drain perpendicular to floor joists?
    if i laminate 3/4" plywood to joists is it ok to drill 21/2" holes to run a 2" drain?
Results 1 to 7 of 7