Search:

Type: Posts; User: Tommyg's old house

Search: Search took 0.07 seconds.

  1. Any info. appreciated about blown insulation into interior walls.

    Hello board. My question is this. I've recently knocked down walls and rolled insulation into walls, re-sheetrocked and spackled.Very time consuming and very very messy! I would like to finish the...
  2. Live in North West New Jersey. Want to get good quality windows..

    Hello board. I'm looking to replace all of my windows. I have a picture window that I would like to replace with a 30 degree angle bay window. Double sliding doors, Kitchen casement window, and 13...
  3. Re: Can someone help me on the correct btu on my new oil burner?

    Thank you for your opinion. I was told that because the furnace is twice the size that it should be it short cycles instead of cycling a little longer. By short cycling it's not as energy efficient...
  4. Re: Can someone help me on the correct btu on my new oil burner?

    Hello Pomer. This question was actually referred to "Jack THe Shack". I was told not to lower the temperature gage because it's the proper setting for the unit that shoudlnt be adjusted. I've...
  5. Re: Can someone help me on the correct btu on my new oil burner?

    Hello Jack. I talked to a plumber who told me that de-rating the nozzle to .85 to .65 that I could do myself and that it's already slanted on that particuliar 45 degree angle already. He also told me...
  6. Looking for new replacement windows cost and performance.

    Hello board. I live in North West New Jersey. Very cold winters. I want to replace all of my windows. Would like to start with the living room which has a picture window, I would like to install a...
  7. Re: How to clean heating element on stove top?

    Thank you for your reply. No it's not the drip pans. They've been replaced. It's the actual heating element on the stove top. If you know what I could use to clean them please let me know.
  8. How to clean heating element on stove top?

    I have an electric stove and from cooking over the years spillage onto the heating element has corroded it somewhat. When i cook the element smokes and I don't know what solution would be best to...
  9. Re: Can someone help me on the correct btu on my new oil burner?

    Hello my friend. You were right. I should be at 60,000btu. I called Crown and had a service tech that was very informative tell me this. He said that I could go as low as .65 on the nozzle. According...
  10. Re: Can someone help me on the correct btu on my new oil burner?

    Thank you for the reply. I remember my old furnace, it was a Rheem. I had service information dating back to 1980 on it.It was replaced in February of 2007 by my current boiler. You state that my...
  11. Can someone help me on the correct btu on my new oil burner?

    Old furnace finally went out after almost 30 years last winter. Had a Crown oil boiler furnace as the replacement.I have baseboard heat. My homes heated living space is about 990 square feet,my...
Results 1 to 11 of 11