Search:

Type: Posts; User: sclowry

Search: Search took 0.29 seconds.

  1. Thread: Pantry sag

    by sclowry
    Replies
    7
    Views
    4,135

    Re: Pantry sag

    Here is a shot with one side of the pantry swung open. It is from the top looking down. I did not even notice that silver screw :) That was simply too obvious. I see that the whole shelving unit...
  2. Thread: Pantry sag

    by sclowry
    Replies
    7
    Views
    4,135

    Re: Pantry sag

    Here is the front looking down. its hard to see but when the pantry swings open, it hots the bottom part of the cabinet and i have to lift the beast up to get it to open....
  3. Thread: Pantry sag

    by sclowry
    Replies
    7
    Views
    4,135

    Pantry sag

    One of my cabinets is this tall pantry unit. It has a middle support, and two hinged sides that have shelves and swing out. The issue I have is the weight of the items, over time, has caused the...
  4. Replies
    0
    Views
    320

    Sump pit is smelly

    My sump pit has a cover, however it is a big slot to allow the pipes and power cord to have access. There seems to be some foul smells from the pit. Any ideas out there to seal it up? I have seen...
  5. Replies
    1
    Views
    440

    Washing Machine - Power Shutoff

    I have seen water detection products on the market that will detect water leaks from a washing machine and shut off the water supply. However, are there any detectors that will kill the power to the...
  6. Replies
    0
    Views
    350

    Washing Machine Power Shutoff

    I have seen water detection products on the market that will detect water leaks from a washing machine and shut off the water supply. However, are there any detectors that will kill the power to the...
  7. Replies
    3
    Views
    1,233

    Re: Taco Pump Leaks (again)

    My 110 only has one flange. How would I replace it with the 007 which has two flanges?

    Thanks for the reply. I really appreciate it.
  8. Replies
    3
    Views
    1,233

    Taco Pump Leaks (again)

    I have a Taco Model 110 pump that is leaking. It was installed around 1970. It leaked before and I replaced the seals about three years ago. The new seals held for a while but now it has started...
  9. Replies
    8
    Views
    1,603

    Re: Patio door too tall

    Well my plan was to install some LockDry waterproof decking. I want to make sure I get the proper slope on the deck. I want to do this right so I wanted to avoid having the door drip edge be below...
  10. Replies
    8
    Views
    1,603

    Re: Patio door too tall

    My door is already just under the header so I cannot raise it at all. I do need to have a "no-no" step because my deck (that the door opens up to) needs to be raised. There is no slope for the water...
  11. Replies
    8
    Views
    1,603

    Patio door too tall

    I have a standard patio door going out to my deck. It measures the standard 80" tall. I need to replace it with a smaller door. I need to raise it about 6 inches on the bottom & I have no room at the...
  12. Replies
    1
    Views
    486

    Patio door too tall

    I have a standard patio door going out to my deck. It measures the standard 80" tall. I need to replace it with a smaller door. I need to raise it about 6 inches on the bottom & I have no room at the...
  13. Replies
    7
    Views
    619

    Re: Ignition problem on boiler

    Nashua,

    Thanks again for your guidance. Your analysis was spot on. After your assistance in diagnosing the high voltage transformer as the culprit, I located and replaced it with a new one. Now my...
  14. Replies
    7
    Views
    619

    Re: Ignition problem on boiler

    Nashua,

    I am new to the PM service so I wanted to let you know I sent you a message.

    -Stuart

    PS: Thanks for the help.
  15. Replies
    7
    Views
    619

    Re: Ignition problem on boiler

    I think I updated my account to allow private messages.

    This is the unit I keep hitting the reset on:
    http://www.climatedoctors.com/items/item.aspx?itemid=429817
  16. Replies
    7
    Views
    619

    Ignition problem on boiler

    My boiler throws its breaker all the time (the one on the igniter unit). I typically have to light a piece of paper to get it to fire. Once it fires up it burns normally. Is this typically a problem...
  17. Replies
    2
    Views
    650

    Re: Replacing water in the boiler

    That did the trick. Thanks for your help.
  18. Replies
    2
    Views
    650

    Replacing water in the boiler

    I had a leaky seal that I replaced on my recirculator pump. I drained the water from my system and everything went pretty well. There is no leak anymore and the pump works fine. The issue I have is...
Results 1 to 18 of 18