Search:

Type: Posts; User: doingitall

Search: Search took 0.06 seconds.

  1. Replies
    3
    Views
    858

    Re: Leaks in ductwork.

    They determined it was leaking based on the small amount of air coming out of the vents. There has never been a lot of air coming out so it was difficult to notice a difference. I didn't think...
  2. Replies
    3
    Views
    858

    Leaks in ductwork.

    Hi,
    I desperately need help. Living in Houston and my upstairs is hot and humid. I've had at least 4 A/C experts come to my house and nobody has been able to figure out why the system is not...
  3. Thread: Warped Door

    by doingitall
    Replies
    4
    Views
    1,491

    Re: Warped Door

    Hi,

    The door is always warped.
    Only one door is warped.
    Live in Houston
    doors are 2 years old
    made of all wood
    house is ACed all year
    door faces east
    sun strikes doors in the morning only.
  4. Thread: Warped Door

    by doingitall
    Replies
    4
    Views
    1,491

    Re: Warped Door

    The outder edge is wood and the inside is all glass.
  5. Thread: Warped Door

    by doingitall
    Replies
    4
    Views
    1,491

    Warped Door

    I have an exterior French door that is warped at the top of one door towards the inside of the house. Is there anything I can do to correct this?
  6. Replies
    0
    Views
    800

    Floating a mexican tile floor

    Is it possible to float a mexican tile floor with concrete to make the floor flat and seamless? My tile floor is in bad shape and I am not inclined to ripping it out. Due to the nature of the tile,...
  7. Replies
    15
    Views
    17,791

    Re: Electric wall oven connection

    I appreciate everyone's input and as it seems like this is much too complicated for my limited knowledge of electrical work, I will call an electrician to swap out my 40 amp for a 30 amp. Once that...
  8. Replies
    15
    Views
    17,791

    Re: Electric wall oven connection

    The panel says Bryant as the manufacturer. Where do I find the size of the main breaker?
  9. Replies
    4
    Views
    6,213

    Using MDF for cabinet doors

    Is MDF a good material for cabinet doors and drawer fronts? From what I understand this material takes paint very well.
  10. Replies
    15
    Views
    17,791

    Re: Electric wall oven connection

    What would happen if I did not change the breaker to 30 amp? It seemed like JLMCDANIEL said it was not required.
  11. Replies
    15
    Views
    17,791

    Re: Electric wall oven connection

    Hi, the old oven was 220. It is on a two pole breaker (each pole says 40 on it (40amps?)), with the black and white wire each measuring120.

    I'm not sure about the gauge but it is very thick and...
  12. Replies
    15
    Views
    17,791

    Electric wall oven connection

    I purchased a new kitchen aid electric wall oven to replace an old electric oven. The new oven has a black, white, red and ground wire while the supply wires are only black, white and ground. I...
  13. Replies
    7
    Views
    3,205

    Re: galvanized to copper pipe size

    thanks to everyone for your useful advice.
  14. Replies
    7
    Views
    3,205

    Re: galvanized to copper pipe size

    Yes, thanks. I already looked at the dielectric unions and only found 3/4 inch. Do they make them in 1/2inch?
  15. Replies
    7
    Views
    3,205

    Re: galvanized to copper pipe size

    There is some build up but it is a small amount surprisingly after about 35 years. It sounds like going to 3/4 would be a large drop in pressure.
  16. Replies
    7
    Views
    3,205

    galvanized to copper pipe size

    I am remodeling my kitchen and need to move hot and cold water pipes. I currently have 1/2 inch galvenized pipes. I want to replace with copper and accidentally bought 3/4 inch copper. What would...
Results 1 to 16 of 16