• NashuaTech's Avatar
    03-26-2014, 11:08 PM
    Check the PITCH of the drain pipes (not visible in the photos you posted) after the trap---they must all have a DOWNWARD PITCH, even if it is only a...
    9 replies | 379 view(s)
No More Results

2 Visitor Messages

  1. hi how are you? i was refered to you by another user on this forum in hopes that you can help me out below is what i got going on.


    ok here we go...i have a carport that i boxed in so i could have another room in my home...i have the washer and dryer on the other side of one of the walls and i want to cut into that wall and tap into the hot and cold water as well as the drain so i can add a sink in my added room...ok, i understand and know how to do the water part with no problem but my question is what is the best way to tap into the drain and install the p trap for the new sink?...first off there is about a 16" drop between the two rooms so i will be below the washer drain, and that is why i am asking about this before i start the task...my thoughts are just to find out what size the drain is and cut it and add a tee then tap in like that but does this sound ok or is there another way i should do this?? please help!
  2. View Conversation
    Thank you very much for your quick response. You are right, the PSI is very low 6 to 8 psi. Is there an adjustment on the valve that i can deal with or will I have to call someone in.
Showing Visitor Messages 1 to 2 of 2
About NashuaTech

Basic Information

Statistics


Total Posts
Total Posts
550
Posts Per Day
0.24
Visitor Messages
Total Messages
2
Most Recent Message
03-29-2009 07:12 PM
General Information
Last Activity
03-26-2014 11:08 PM
Join Date
02-15-2008

1 Friend

  1. wvazquew wvazquew is offline

    Junior Member

    wvazquew
Showing Friends 1 to 1 of 1